超高速の仮想通貨取引
固定レートと変動レートの違いとは？
Fixed rate
Opting for a fixed rate, you get the price you see at the point of initiating a transaction.
- Pay just 1% + network fee.
- Rates freeze for 10 minutes.
- If the market rate changes by more than 1.2% before the appearance of your transaction on the blockchain network, you will be asked to make a refund or continue exchanging at the market rate.
Attention! Your transaction must be received within 10 minutes and the amount must exactly match the amount of the order. Otherwise, you will be prompted to make a refund or continue the exchange at the market rate.
Float rate
The exchange rate is finally set when your transaction receives the necessary number of blockchain network confirmations. If the market goes up, you will get more cryptocurrency, if down - less. All fair.
- Pay just 0.5% + network fee.
- The exchange will be made at the market rate, which is finally set within 10 minutes after your transaction receives the required number of confirmations in the blockchain network.
Example: you are exchanging 1 BTC for 28.37362388 ETH. With a fixed rate, you will receive exactly 28.37362388 ETH. With a float exchange rate, the amount of ETH can change both up and down. It depends on changes in the market rate.
トランザクションの送信と受け取った資金の統合のための総ネットワーク手数料が、この方向のための総取引額において著しい部分を占めることにご注意ください。
この量の取引では、まったく利益がでない可能性があります。
この問題の詳細につきましてはレートの形成に関する本サイトの記事をご参考いただけます。
Important Notice
U.S. persons cannot make an exchange on FixedFloat.com
Chainlink (ERC20) to Monero
3ステップの取引
- お望みのChainlink (ERC20)の量と、通貨を受け取るウォレットのアドレスを入力してください。
- 「今すぐ取引」ボタンをクリックすると、注文内容ページに移動します。
- 注文からアドレスにChainlink (ERC20)を送信すると、必要なネットワーク確認が行われた後、Moneroが瞬時に送信されます。
知っておくべきこととは？
Chainlink at a glance
Chainlink is a cryptocurrency based on the Ethereum blockchain. The LINK token inherits the functionality of the ERC-20 standard, although it itself complies with the ERC-677 standard.
Chainlink (LINK) is the first decentralized oracle service of its kind. The ChainLink project allows smart contracts to use ChainLink oracle services to interact with systems of other payment networks using various APIs.
LINK smart contract
Do not submit LINK through a third party contract. Our exchanger does not accept transactions that are sent by third party smart contracts, except for the original LINK contract.
Network fee
To work with tokens, the wallet must have ETH. It is very difficult to calculate the exact amount of ETH to send a transaction. During periods of high load, it can change significantly. Each token can have a different transaction value. Therefore, it is better that the amount of ETH on the wallet is slightly higher than the average fee on the network at the moment. The average fee can be estimated using the Blockchair analytical service.
The system does not see the transaction, what should I do?
If you have sent funds, but there are no changes, check your transaction in an explorer (etherscan.io or blockchair.com) and make sure that the transaction was created.
If the transaction has already been added to the blockchain, and the system has not seen it, contact technical support, we will be able to help you promptly.
Monero is the most anonymous cryptocurrency
Monero runs on the CryptoNote algorithm, unlike public blockchains (e.g. Bitcoin, Ethereum etc.), when sending it, you can not see the sender, the recipient, or even the amount that was sent. This is possible due to the use of Ring Signatures and Stealth Addresses technologies.
What to do if you did not receive Monero after the exchange?
First, make sure that the order contains data about the transaction sent. In case there is no transaction data, try to wait a bit or contact technical support. Due to the fact that in the Monero network updates from November 30 at the protocol level, funds are blocked until 10 network confirmations are received, delays in payment may sometimes occur.
Secondly, check the synchronization of your Monero wallet. The last block in the wallet should correspond to the number indicated on the MoneroHash website in the "Blockchain Height" field of the "Network" block. If not, try restarting your wallet.
If the order contains the data of the transaction we sent, the wallet is synchronized, but the transaction is not visible in the wallet, contact technical support to request a private viewing key to decrypt the transaction and confirm the sending of funds.
When can I use the resulting Monero?
As mentioned above, in the Monero network updates dated November 30 at the protocol level, funds are blocked until 10 network confirmations are received. That is, until the transaction receives 10 confirmations, it will not be possible to use the funds received. On average, a transaction receives 10 confirmations within 20 minutes.
Transaction processing speed
The average block release time is about two minutes. But sometimes delays do occur, and the block exit time can take 10-20 minutes.